RocketFish RF-RBWS02 - Manual (Page 30)

30
Troubleshooting
Check this list for a possible solution before calling for service.
Problem Solution
No sound • Make sure that the AC adapter is connected to the sender and the power cord is connected to
the receiver.
• Make sure that all of the cables are connected correctly.
• Make sure that the receiver is not muted. (The source indicator is blinking when it is muted.)
• Make sure that the power-on indicators are lit on both the sender and receiver. If the power-on
indicators are lit solidly, the communication is working correctly. If they blink at a slower rate,
see the “no communication between sender and receiver” section.
• Make sure that the volume is turned up on the source device.
Sound interference • Move your sender and receiver slowly to find the best reception position for your system.
• Shorten the distance between your sender and receiver. The maximum distance is 150 ft
(45 m) (unobstructed).
• Make sure that there are no obvious radio frequency interference sources near your system.
.
.
. .
.
.
Stream A Stream B
Up to nine receivers
Back of sender
Speaker-in B Speaker-in A
RF-RBKIT_09-0473_MAN_ENG_V1.fm Page 30 Thursday, August 27, 2009 6:44 PM