Revolutionary Cooling Systems PVP2800 - Manual (Page 7)

4. Attach the lower bracket to the inverter using the two screws provided.
5. Insert the two mounting screws through the mounting holes located below the
power board at the bottom of the cabinet and tighten securely.
Figure 3
5. Carefully bring the inverter right side up and hang it on the upper bracket.
6. Verify inverter is level. Seal the upper mounting holes on the inverter with
RTV.
7. Mark the locations of the lower mounting bracket holes. Drill holes into studs
or install wallboard anchors as necessary.
8. Screw in the bottom screws of the bottom bracket to anchor the bracket to the
wall. Refer to Figure 4.
Figure 4: Mounted StarInverter with Mounting Brackets in place.
PLEASE NOTE: Leave the inverter cover off to allow for electrical
connection in section 2.3.
PV Powered LLC 6 18-28-405