System setup – ResMed H4i User Manual
Page 4
2
System Setup
1
Align your H4i with your flow generator and push them together until they click into
place.
2
Connect the power cord to the socket on the rear of your flow generator.
3
Plug the other end of the power cord into the power outlet.
Place the combined unit on a firm, level surface near your bed at a level lower than
your sleeping position. Ensure the surface is not sensitive to heat and/or moisture, or
use a protective mat.
4
Connect one end of the air tubing firmly onto the air outlet
.
5
Connect the assembled mask system to the free end of air tubing.
!
WARNING
•
Make sure your flow generator is switched off at the power outlet before
connecting the H4i.
•
The H4i docking station should only be connected or disconnected when the
water chamber is empty.
•
Water must be prevented from entering your flow generator. Do not
transport the flow generator with the H4i attached.
1
2
4
5
3