Ryobi BS1001SV - Manual (Page 14)

Page 14
ASSEMBLY
n Use the same steps to install the lower braces. Tighten
all hex nuts with a wrench.
n Place a carriage bolt in each of the four holes on the top
of the leg stand and secure with a hex nut.
n Tighten securely.
n Place one foot on the bottom of each of the legs.
n Move the leg set to desired location.
TO MOUNT THE BAND SAW TO THE LEG
STAND
See Figure 8.
n
Take the following from a small hardware bag:
3 hex bolts
3 hex nuts
3 flat washers
NOTE: This hardware was in the bag with hardware for
assembling the leg stand.
WARNING:
The saw base is heavy. Do not lift the saw without help.
When lifting, lift close to your body. Keep your knees
bent and lift with your legs, not your back. Ignoring these
precautions can result in back injury.
n Place the band saw on the leg stand. Align the holes in
the saw base with the holes in the upper braces.
n Place a flat washer on a hex bolt and insert through hole.
Add a hex nut. Hand tighten. See Figure 9.
n Repeat for remaining holes. Tighten all hardware with a
wrench. You may find it helpful to use one wrench to hold
the head of the hex bolt and one to tighten the hex nut.
TO MOUNT THE SAW TABLE
See Figures 9 - 10.
n
Standing at the front of the band saw, slide the saw table
(past the blade) through the slot moving from the left side
of the saw table to the right.
n Align the screw holes in the saw table with the holes in
the saw table bracket.
n Using the screws, attach the saw table to the saw table
bracket. Tighten phillips screws securely.
n Attach the table aligning bolt, washer, and wing nut to
the saw table.
NOTE: The wing nut and washer goes below the saw
table.
Fig. 9
SCREW
SAW
TABLE
SAW TABLE
BRACKET
Fig. 8
HOLES IN
SAW BASE
HEX NUT
WASHER
LEG STAND
SAW BASE
HEX NUT
FLAT
WASHER
MOUNTING BOLT
MOUNTING
BOLT