Radio Shack PLCD32 - Manual (Page 8)

8
RADIO OPERATION
• BAND SELECTION
At tuner mode, press BND/LOU button (13) shortly to select the desired band.
The reception band will change in the following order:
• STATION SELECTION
Press TUNE/SEEK/TRACK button (16) or TUNE/SEEK/TRACK button
(17) shortly to activate automatic seek function. Press for several seconds until
“MANUAL” appeared on the display, the manual tuning mode is selected. If both
buttons have not pressed for several seconds, they will retune to seek tuning mode
and “AUTO” appeared on the display.
• LOCAL/DISTANCE
Press LOC button (2) to select between local and distant stations.
Local setting for reception of strong station, and a distant setting for reception of
weaker stations. This function is effect during AUTO SEEK operation.
• AUTOMATICALLY MEMORY STORING & PROGRAM SCANNING
- Automatically Memory Storing
Press AMS button (18) for several seconds, the radio searches from the current
frequency and checks the signal strength until one cycle search is finished.
And then 6 strongest stations are stored into the corresponding preset number
button.
- Program Scanning
Press AMS button (18) shortly to scan preset station. When the field strength
level is more than the threshold level of stop level, the radio is holding at that
preset number for several seconds with releasing mute, then searches again.
• STATION STORING
Press any one of the preset buttons (14) (M1 to M6) to select a station which had
been stored in the memory. Press this button for several seconds, current station
is stored into the number button.
• MONO/STEREO
Press MON button (1) to select mono or stereo mode. You can sometimes improve
reception of distant stations by selection mono operation.
FM1 FM2 FM3 AM