RedMax HBZ2610 - Manual (Page 11)

US-11
HBZ2610
U
S
Except for an emergency, avoid stopping
the engine while pulling the throttle
trigger.
■ ADJUSTING IDLE SPEED
1. When the engine tends to stop
frequently at an idle mode, turn the
adjusting screw clockwise.
(1) Idle adjusting screw
(2) Cable adjuster
Warm up the engine before adjusting the
idle speed.
NOTE
NOTE
F7
F6
8. Operation
■ STARTING ENGINE
1. Rest the unit on a flat, firm place.
2. Pump the primer until fuel flows out in
the clear tube.
(1) Primer
3. Move the choke lever upward to close
the choke.
(1) Choke lever
(2) Close
(3) Open
4. Holding the blower handle, pull the
starter rope with your right hand.
(Throttle trigger in idling position.)
Avoid pulling the rope to its dead end or
returning it by releasing the knob. Such
actions can cause starter failures.
5. When the engine has started, move the
choke lever gradually downward to
open the choke.
6. Allow the engine to warm up for a half
minute before starting operation.
■ RESTARTING ENGINE WHILE
ENGINE IS HOT
1. When restarting the engine
immediately after stopping it, leave the
choke open.
2. If the engine won't start after several
attempts, close the choke and repeat
pulling the rope or remove the spark
plug and dry it.
■ STOPPING ENGINE
Move the throttle trigger to the idling
position and press the stop switch (red
button) until the engine comes to a
complete stop.
(1) Stop switch
NOTE
F3
F4
F5