Mounting the main module, Installing the status indicator – Radio Shack RS-4000 User Manual

Page 12

Advertising
background image

12

Need Help? Call 1-800-598-2527

3. Use pliers to squeeze down the

tapping blade.

4. Close the insulated cover so it

snaps.

MOUNTING THE MAIN
MODULE

Select a location for the main module
where it is completely concealed and
difficult to access after installation. An
ideal location is usually under and be-
hind the vehicle’s dashboard on the
firewall. Use two of the supplied wire
ties to secure the main module under
the dash.

INSTALLING THE
STATUS INDICATOR

Use the supplied mounting bracket to
hold the indicator or drill a hole in the
dash. Follow these steps to install the
indicator.

1. To use the supplied mounting

bracket, use denatured alcohol
to clean the surface and let it dry
completely. Peel the backing off
of one side of the double-sided
tape and press it onto the bottom
of the bracket. Then peel the
adhesive backing from the other
side of the tape and press the
bracket onto the dash.

To mount the indicator in the
dash,
drill a

1

/

4

-inch hole at the

desired location. The surface
should be less than

1

/

8

-inch thick.

2. Press the supplied grommet into

the mounting hole from the front
of the surface.

3. Press the indicator into the grom-

ment from behind the surface.

4. Plug the indicator’s plug into the

matching jack on the system.

5. Use a supplied wire tie to secure

the wire out of the way.

Grommet

Indicator

49-840in.fm Page 12 Thursday, August 19, 1999 10:47 AM

Advertising