Ricoh Type 2018 - Manual (Page 20)

Troubleshooting
14
2
Print overrun. The image data has been
thinned out due to image com-
pression. Increase memory capacity.
When installing a memory
module in the machine, con-
tact your sales or service rep-
resentative.
Problem:IEEE1394 board An error may have occurred in
the IEEE 1394 board. Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Problem:IEEE802.11b card An error may have occurred in
the IEEE 802.11b card.
Problem:IEEE802.11b board An error may have occurred in
the IEEE 802.11b board.
Paper Tray is in use. The specified paper tray is in
use by another function, such
as the copier function. Wait until the other function
has finished using the speci-
fied paper tray.
Reset paper tray correctly. The selected paper tray does
not exist or is not set correctly. Set the paper tray correctly.
DToner is almost empty
Add toner The toner has almost run out. Replace the toner cartridge
soon to prevent poor print
quality.
Tray # Error An error has occurred with the
paper tray.
# indicates the tray number.
Press [JobReset] to change the
paper tray settings, or press
[FormFeed]
to select another
paper tray and print using
that.
Unauthorized user access. Print job canceled due to user
restrictions. Check the User Code permis-
sion status.
USB Error An error has occurred in the
USB interface. Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Messages/Second messages Causes Solutions