Fitting the splashback (optional), Electrical connection, Hob check – Rangemaster Elan 90 Induction Cooker U109987 - 01 User Manual
Page 25: Grill check, Oven check, Fitting the plinth
23
using the Allen screws. Insert the blanking plugs into the
fixing holes.
The fit the front handrail, first remove the 4mm Allen screws
from the top corners of the fascia. Locate the handrail to the
fascia and secure in place.
Fitting the Splashback (optional)
The splashback fits the back of the cooker. It is secured using
4 screws (2 at each end) in the rear edge of the flue grille.
Remove the outer 2 screws and then loosen the inner pair. Fit
the splashback over the inner screws and then refit the outer
screws (Fig.7-9). Tighten all screws to secure.
Electrical Connection
The cooker must be installed by a qualified electrician, in
accordance with all relevant British Standards/Codes of
Practice (in particular BS 7671), or with the relevant national
and local regulations.
WARNING: THE APPLIANCE MUST BE EARTHED.
Note: The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
a suitable cooker control unit incorporating a double pole
switch, having a contact separation of at least 3mm in all
poles.
The cooker must not be connected to an ordinary
domestic power point.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your electrical
supply type (Fig.7-10 and Fig.7-11). Check that the links are
correctly fitted and that the terminal screws are tight. Secure
the mains cable using the cable clamp.
Hob Check
Check each cooking zone in turn. Be sure to use pans of the
correct size and material.
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Set the clock as described earlier, and then turn on the ovens.
Check the oven fans start to turn and that the ovens heat up.
Fitting the Plinth
Loosen the three screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and fit each end keyhole over their respective screws. Tighten
the fixing screws (Fig.7-12).
Please complete your contact details in the front of this
section. Please inform the user how to operate the cooker
and hand over the instruction pack.
Thank you.
ArtNo.421-0001 - Fitting a splashback Classic
Fig.7-9
ArtNo.130-0010 Electrical connections single-phase
�
�
������������
�����
���
ArtNo.130-0010 Electrical connections 3-phase
��
�
��
��
�����
�������������
����
���
�����
���
Fig.7-10
Fig.7-11
ArtNo.000-0012 - Securing the plinth
Fig.7-12