RIDGID R5010 - Manual (Page 8)

8 9
Fig. 1
FORWARD-REVERSE/
CENTER LOCK OFF
LEVER
AUXILIARY HANDLE
ASSEMBLY
SWITCH
TRIGGER
LOCK-ON
BUTTON
DEPTH GAUGE
ROD
AUXILIARY HANDLE ASSEMBLY
An auxiliary handle is installed on the hammer drill. For ease
of operation, you may use the handle with either the left hand
or the right hand.
REVERSIBLE
This hammer drill allows you to reverse the bit rotation. You
can control the direction with the switch located on the side
of the tool.
PULSE MODE DRILLING
Allows for working with damaged screw heads, countersinking
screws in wood, unscrewing very tight screws, and starting
a drill bit on hard, smooth surfaces.
FEATURES
Before using this tool, familiarize yourself with all operat-
ing features and safety requirements. However, do not let
familiarity with the tool make you careless.
This new drill is equipped with the following features. See
Figure 1.
SWITCH
This hammer drill has a conveniently located switch
trigger.
DEPTH GAUGE ROD
A depth gauge rod is installed on the auxiliary handle
assembly to assist you in controlling the depth of drilled
holes.
SPECIFICATIONS
Chuck Capacity............................................................................................................................................... 1/2 in. (13 mm)
Input .................................................................................................................................... 120 V, 60 Hz, AC only, 9.0 Amps
Switch..............................................................................................................................................................Variable Speed
Hammer Speed ................................................................................................................................................0-57,000 BPM
No Load Speed ........................................................................................................Low (0-1,000/min) & High (0-3,000/min)
KEYLESS CHUCK