RGB Spectrum Quadra User's Guide - Manual (Page 27)

I N S T A L L A T I O N A N D S E T U P
System Timing
350-7951 Quadra User’s Guide 19
.
. .
.
.
With the IP address and port properly entered, the Telnet window
opens and Quadra responds with the product name and copyright
notice as shown in the sample below.
Figure 2-5. Quadra Login (Sample)
4. To confirm the connection, in the Telnet window type:
ID
… and press Enter . Quadra responds with a variety of product details
including the unit’s IP settings.
You can now control Quadra directly by issuing ASCII commands
from the Telnet terminal. Refer to Chapter 4, “
Command Line
Interface ” for a complete command list.
5. Please continue with the “ System Timing ” section.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S Y S T E M T IM IN G
The following topics are outlined in this section:
• Introduction to Timing
• Output Timing
• Advanced Output Timing
• Input Timing
INTRODUCTION TO
. . . . . . . . . TIMING
For the best visual results with Quadra, the timing parameters of a signal must
match the display device. Please note:
• For each of Quadra’s four output channels, each channel’s output
settings should match the connected display.
• For each of Quadra’s four graphics inputs, Quadra’s input settings
should match the characteristics of the input signals.
Note To close a Telnet session, type EXIT or use the keystroke
sequence “ Control + D .”