Radio Shack 43-5560 - Manual (Page 32)

P
honebook
32
5. Press the number keypad to enter the
phone number (up to 20 digits), press
the
OK soft key to store the number.
Ô
6. Distinctive Ring appears. Press
VOL/RING/ or VOL/RING/ to move
the pointer to one of the Distinctive
Ring options, and then press the
OK
soft key.
Ô
7. Speed Dial appears. Press
VOL/RING/ or VOL/RING/ to move
the pointer to select the Speed dial
location (ten locations: SPD1-SPD0).
Ô
8. Press the OK soft key. You will hear a
confirmation tone, and Done! appears
in the display.
S
TEPS FOR
E
NTERING
N
AMES
AND
S
PECIAL
C
HARACTERS
Refer to the letters on the number keys to
select the desired characters. With each
press of a number key (
0 - 9 ), the displayed
character appears in the following order:
upper case letters first, lower case letters
next and finally the number corresponding
to the key.Ф
Ф
NOTES
Ô
Storing Phone Numbers,
Names, Distinctive Rings,
and Speed Dial
•
The pause key counts as
one digit. Pressing the
PAUSE soft key, more
than once increases the
length of the pause
between numbers. Each
pause represents a two
second delay.
• If you choose not to
store a “Distinctive
Ring”, simply select the
“No Selectn” option.
• Selecting a speed dial
location where a number
is already stored,
releases the old
number’s speed dial
setting. The new number
will be stored in the
speed dial location.
• If you choose not to
store the name/number
as a Speed Dial, simply
select the “No Selectn”
option.
Steps for Entering Names
and Special Characters
• If the next character
uses the same number
key, you must press #
/>
to move the cursor over.
Otherwise the next time
you press the number
key, it changes the
character that was
previously set.
Number of times key is pressed
43-3580.book 32 ページ ２００４年１月２６日 月曜日 午前１０時１９分