Roland XV-3080 - Manual (Page 101)

101
Chapter 4 Creating a Patch
Chapter 4
4. Use [ ] / [ ] to make “COPY” blink, and then
press [ENTER].
The Patch TONE CPY page will appear.
fig.4-34.e
5. Press [ ] / [ ] to move the cursor to the
parameter that you wish to set.
6. Turn the VALUE dial or press [INC] [DEC] to select the
desired value.
7. Press [ENTER] to execute the Copy – an asterisk (“*”)
appears before the copy destination Tone in the display.
fig.4-35.e
8. Press [EXIT] to return to the PATCH PLAY page.
* To specify the currently selected Patch as the copy source, set
Source to “TEMP.”
Copy source Patch
(group, number)
Copy source Tone
Copy source Patch name
Copy destination Tone
Compare Function
You can use the Compare function during the Patch
Tone Copy operation to play the source Patch. To do so,
press [UNDO] to access the PATCH COMPARE page. A
new source Patch can be selected from the PATCH
COMPARE page as well – however, it is not possible to
select Patches from XP-A–F. After selecting the desired
Patch, return to the previous page by pressing [UNDO]
or [EXIT].
fig.4-36.e
* The Compare function cannot be used with Patch Tone
Copy if TEMP patch is selected as the copy-source Patch.
* Please be aware that when the Compare function plays a
Patch, it may sound somewhat different than when it is
played normally.
Copy source Patch (group, number, name)
Patch Name Copy
You can copy the name of a Patch to the current Patch.
fig.4-37.e
1. Select the Patch you want to copy.
2. Press [UTILITY] to make its indicator light.
3. Press [ ] / [ ] to select the UTIL 1 page.
4. Use [ ] / [ ] to make “COPY” blink, and then
press [ENTER].
5. Press [ ] / [ ] to select the PATCH NAME CPY
page.
6. Turn the VALUE dial or press [INC] / [DEC] to
select the desired source Patch.
7. Press [ENTER] to execute the Copy operation.
Copy source Patch (group, number, name)