RightWay GPS Navigator RW 355 - Manual (Page 114)

Mounting System
Included in your package, you will find a mounting solution to easily secure your RightWay
Navigator to either the windshield or the dash.
NOTE: It is illegal in California and Minnesota to attach anything to the windshield.
1. Select a suitable location on the windshield or dashboard for the mount. Clean and
dry this area to remove any grease and dirt.
2. If mounting the GPS on the dashboard, remove the protective
backing from the dash disc, exposing the adhesive. Adhere
the disc to the dashboard in the desired location.
NOTE: The adhesive is permanent.
3. With the locking lever in the up position, hold the suction cup to the windshield or on
the dash disc with the locking lever and pull tab on top.
4. Push the locking lever towards the base of the mount. The mount should suction to
the surface.
5. Align the tabs on the holder with the slots on the Navigator cradle. Slide together
until you feel a firm click.
6. Adjust the holder to the best viewing angle by loosening the adjustor dials, moving
the corresponding part to the desired position, and then tightening the adjustor dial.
7. To remove the mount, pull the locking lever away from the base, then gently pull on
the pull tab. This should break the suction so you can remove the mount.
Dash Disc
Adjuster Dial
Up & Down
Locking Lever
(in up position)
Pull Tab
Adjuster Dial
Right & Left