Rival VS110 - Manual (Page 3)

KNOW YOUR SEAL-A-MEAL ® VACUUM FOOD SEALER
UPPER LID
SEAL BUTTON
SEALER INDICATOR LIGHT
SEALING SURFACE
VACUUM INDICATOR LIGHT
VACUUM BUTTON
REMOVABLE DRIP TRAY
BAG ROLL CHAMBER
NOZZLE
SPRING-LOADED BAG HOLDER
BAG CUTTER
PLUG - (BACK OF UNIT)
MOUNTING KEY HOLES
- (BEHIND UNIT)
-4- -5-
Seal-a-Meal ® bags are provided in two different ways – on customizable
Rolls (8" and 11" wide) and pre-cut bags (1-Quart and 1-Gallon sizes).
Our durable bags are made of high-density material that can be frozen,
boiled, are microwave safe and are reusable. The pattern that appears on
the bag helps provide an airtight seal that lasts longer than standard zip
or sandwich bags.
ABOUT YOUR SEAL-A-MEAL ® BAGS
1. Bore two holes (300 mm apart; 6 mm diameter) along a straight line
on the wall.
2. Hammer one screw anchor into each wall hole.
3. Screw the screws into screw anchors leaving 8 mm head outside of
the wall.
4. Hang sealer on the screw heads.
Note: Mounting is for storage only.
The item should not be used on
the wall.
MOUNTING YOUR SEAL-A-MEAL ® VACUUM FOOD SEALER
1. Plug in the power cord.
2. Open the lid.
3. Place the open end of the Roll onto the
sealer surface.
4. Close lid until it locks into place.
5. Press the SEAL BUTTON and The
Seal-a-Meal ® Vacuum Food Sealer will
automatically start sealing that end of the
bag.
6. Once the sealing INDICATOR LIGHT goes off,
open the lid by pressing the LID RELEASE
BUTTONS located at the sides of the unit.
7. Remove bag from unit.
8. Cut a piece from the Roll that is long enough
to cover the item you wish to seal, leaving
extra room to allow for contraction when
the item is sealed. Use the integrated BAG
CUTTER located along the front of the unit to
ensure a safe, even cut.
9. Place item you wish to seal into bag. Make
sure item is laying flat, or is placed how you
want it to be stored.
10. Open the lid.
HOW TO USE YOUR SEAL-A-MEAL ® VACUUM FOOD SEALER
WITH THE INTEGRATED BAG ROLL
LID RELEASE BUTTONS
VS11003EM3 4/1/03 10:59 AM Page 4