Radio Shack PRESIDIAN 42-179 - Manual

Portable CD Player with Car Kit
42-179
Connecting Your CD Player
For private listening, connect the supplied earphones or
optional headphones with a 1/8-inch (3.5mm) plug into
the PHONES jack on the CD player.
To listen through your home audio system, connect an
audio cable (not included) with a 1/8 -inch (3.5-mm) plug
to the CD player’s LINE OUT jack, and connect the cable
to your audio system’s audio input jacks. Then, use the
system’s volume control to adjust the volume.
User’s Guide
©2007. RadioShack Corporation. All rights reserved. Presidian is a registered trademark used by RadioShack Corporation.
Thank you for purchasing your Portable CD Player with Car Kit
from Presidian. Please read this user’s guide before installing,
setting up, or using your CD player.
In This Package
Portable CD Player Earphones
Car Kit Charging Ring
User’s Guide
Battery Notes:
• Dispose of old batteries promptly and properly.
Do not burn or bury batteries.
• Use only fresh batteries of the required size and
recommended type.
• Do not use batteries of different types,
capacities, or chemistries.
• If you do not plan to use your CD player for a
week or more, remove the batteries. Batteries
can leak chemicals that can damage electronic
parts.
• Replace or recharge batteries when the low
battery icon appears.
RF Emissions Information
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult your local RadioShack store or an experienced radio/TV
technician for help.
If you cannot eliminate the interference, the FCC requires that you stop
using your CD player. Changes or modifications not expressly approved
by RadioShack may cause interference and void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Limited 90-Day Warranty
This product is warranted by RadioShack against manufacturing defects in material
and workmanship under normal use for ninety (90) days from the date of purchase
from RadioShack company-owned stores and authorized RadioShack franchisees
and dealers. For complete warranty details and exclusions, check with your local
RadioShack store.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102
04/04
Powering Your CD Player
Installing Batteries
Open the CD compartment door
and the battery compartment
cover to insert two AA alkaline
batteries (not supplied) matching
the polarity
(+ and -) marked inside.
Rechargeable Batteries
Charge Ni-Cd (or Ni-Mh) rechargeable batteries (not
supplied) before using your CD player.
1. Use an AC adapter (not included) to connect your
CD player to a standard wall outlet.
2. Cover the negative end of one battery with the
supplied charging ring and place the batteries in
the compartment matching the polarity (+and-).
3. Switch CHARGE ON/OFF
on the back of the CD player to ON.
When charging is complete, slide
the switch to OFF to avoid damaging
the CD player and disconnect the AC
adapter.
Using an AC Adapter
You can power
your CD player
using a 4.5V 500
mA AC adapter (not
supplied). Insert
the barrel plug into the CD player’s DC 4.5V jack and
plug the other end of the adapter into a standard AC
outlet.
Note: You must use a Class 2 power source that
supplies 4.5V DC and delivers at least 500 mA. Its
center tip must be set to positive and its plug must fit
the CD player’s DC 4.5V jack. Using an adapter that
does not meet these specifications could damage the
CD player or adapter.
Using the Vehicle Adapter
Insert one end of the DC
adapter into the DC IN jack
and plug the other end into the
cigarette lighter in your vehicle.
charging ring
LINE
OUT
PHONE VOLUME
PROG.
See
Programming Tracks.
BBS
Press to enhance the bass.
PUSH OPEN
Press to open the CD door.
MODE
Press repeatedly to select a playback mode:
• INTRO - The CD player will play the first
ten seconds of each track. Press again until
INTRO disappears to cancel intro scan.
• RND – Plays tracks randomly.
•
– Repeats playback of the current CD or
MP3 track.
• ALBUM – Repeats playback of all the MP3
tracks of current album.
• ALL or ALL ALBUM – Repeats all CD tracks
or all tracks of all MP3 albums.
Note: When the CD player reaches the end
of the CD or the programmed sequence, it
returns to the first track and replays all the
tracks.
ESP/DIR
-
Activates 45 seconds of
anti-shock for CDs (120
seconds for MP3 CDs). ESP
appears when active.
-
MP3-CDs only: skips to
an album / first track of an
album.
§
Press to turn on the player and start play. Press
again to pause playback.

Press to stop playback. Press again to turn off
the player.
 
• Press repeatedly to locate a track. When the CD is playing, press  once to return to the beginning of the current
track.
• To search for a particular section within a track, hold down  or  during play. The CD player rapidly plays the
CD either backward or forward at a high speed and low volume. When you hear the section you want, release to
resume normal play. This search stops at the end of the last track (or the beginning of track one.)
HOLD ON / OFF
Slide to ON to lock all controls (except
PUSH OPEN and volume control).
HOLD appears on the display. Slide to
OFF to unlock.