Rangemaster 90 CERAMIC U109650-02 - Manual (Page 21)

21
Oven not coming on when turned on manually
Is the power on? Is the clock illuminated?
Is the key symbol ( ) showing in the display? See
the Clock section of the instructions for more
information on the key lock feature of the clock.
If using the Multi-function oven have you set a
cooking function?
If not there may be something wrong with the
power supply. Is the cooker supply on at the
isolator switch?
Oven not coming on when automatic cooking
Timer set correctly but oven knob left OFF by
mistake?
Is the key symbol ( ) showing in the display? See
the Clock section of the instructions for more
information on the key lock feature of the clock.
If using the Multi-function oven have you set a
cooking function?
Oven temperature getting hotter as the cooker
gets older
If turning the knob down has not worked or only
worked for a short time then you may need a
new thermostat. This should be fitted by a service
person.
Grill not cooking properly
Are you using the pan and trivet supplied with
the cooker? Is the pan being used on the runners,
not the floor of the compartment? Is the grill pan
pushed fully back to stop?
When you pull the
grill pan forward is the
wide rim at the front?
It's important that the
wider part is at the front.
The oven light is not working
The bulb has probably blown. You can buy a
replacement bulb (which is not covered under the
guarantee) from a good electrical shop. Ask for an
Edison screw fitting 15w 240v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300 °C. See
the 'Customer Care' leaflet for spares by mail order.
Turn off the power supply.
Make sure the oven is cool. Open the oven door
and remove the oven shelves.
Unscrew the bulb cover by turning anticlockwise. It
may be very stiff.
Taking care to protect your fingers in case the bulb
should shatter, unscrew the old bulb.
Screw in the new bulb, screw back the bulb cover.
Turn on the electricity supply and check that the
bulb now lights.