Radio Shack XL-50 - Manual (Page 12)

12 Completing the Installation
MOUNTING THE AMPLIFIER
Once you verify that the amplifier is connect-
ed properly, follow these steps to mount it.
1. Disconnect the cable from the vehicle’s
negative (–) battery terminal.
2. To make mounting more convenient,
temporarily disconnect the amplifier’s
connections (ground, primary power,
remote power, your auto sound system’s
input, and speakers).
Note: If you have not already done so,
be sure to mark each wire with the name
of the terminal you will reconnect it to.
3. Using the mounting holes on the ampli-
fier as a guide, mark the positions for the
mounting holes.
4. Drill 9 /
64
-inch (3.57 mm) holes at the
marked locations, being careful not to
damage anything behind the mounting
surface.
5. Secure the amplifier to the mounting
surface using the supplied sheet metal
screws and washers.
6. Reconnect the wiring.
7. Reconnect the cable to the vehicle bat-
tery’s negative (–) terminal.
8. Reset your vehicle’s clock, your auto
sound system’s tuner memory, and
other timer/memory devices.
9 / 64 -Inch Mounting Holes
Sheet Metal Screw
Lock Washer
Flat Washer
12-2013.fm Page 12 Tuesday, May 9, 2000 9:09 AM