ROTEL RLC-1080 - Manual (Page 10)

10 RLC-1080 Power Conditioner
Model Number and
Serial Number Screen
This screen displays the model number and serial
number of your unit. Please have this information
available any time you need to talk with Rotel
Technical Support, as well.
����������������
����������������
Internet Address Screen
This screen provides the world-wide Internet
Web address for Rotel.
����������������
INPUT FREQUENCY;
OUTPUT FREQUENCY Screen
This screen shows the AC line frequency of the
power coming from the wall power outlet and
the AC line frequency of the power being sup-
plied to the connected devices.
����������������
����������������
At times, the frequency values on this screen may
not match. This is due to the fact that separate
circuits are used to make frequency measure-
ments, and there is a time delay between the
two circuits for updating this status screen. This
condition is normal.
Note: The display will revert to the default
SOURCE; EST RUNTIME screen after about
30 seconds of inactivity. The default screen
can be changed. See the “Setting the Default
Screen” section of this manual.
Connecting the Components
WARNING: Do not make telephone, cable,
Ethernet, antenna, electrical, or ground system
connections during a lightning storm. Failure to
comply may result in personal injury or death.
The RLC-1080 has four groups of power outlets.
Each group has specialized filtering and surge
protection that are specifically designed for
certain type of components. It is recommended
that you connect your A/V components to the
power outlets that are designed for that type of
unit. For more information see the AC Power
Outlets section of this manual.
Connect the ground connector of each component
in the system to the SYSTEM GROUND terminal
on the RLC-1080. This will eliminate “ground
loops” thus prevent the audible hum that they
might otherwise produce.
Setting Up the RLC-1080
Using the front panel SETUP and Arrow Up/
Down buttons, you can configure or turn on/off,
various functions of the RLC-1080. Pressing the
SETUP push button will display these functions
in the following order:
1. Audible Alarm
2. Sensitivity, Display Dimmer
3. LED Dimmer
4. Go To Battery If <XX Volts,
Go To Battery if >XX Volts
5. Outlet Delay1
6. Outlet Delay2
7. Low Battery Warning
8. Battery Replacement Date
9. Do Quick Selftest
10. Do Runtime Calculation
11. Display Beep Test
12. Screen Saver On/Off, or Reset to Default
AUDIBLE ALARM Setting
When set to ON this provides an audible tone
whenever the unit detects a problem with itself, or
with an externally connected battery pack. In the
OFF setting, the audible tone is silenced.
����������������
������������������
SENSITIVITY Setting
Press the SETUP button to advance to the Sensi-
tivity function. This feature adjusts how the RLC-
1080 reacts to abnormal power input voltage
or momentary power fluctuations. It allows you
to adjust the sensitivity to LOW, MEDIUM or
HIGH using the SETUP and Up/Down Ar-
row buttons. The Sensitivity adjustments have the
following values: