Rosewill RNX-N150PC - Manual (Page 37)

Wireless N Adapter RNX-N150PC User Manual
Chapter 7 Setup Examples Guide
7.1 WMM Setup Examples
7.1.1 Example to configure to Enable DLS (Direct Link
Setup)
1. Click "WMM Enable" to enable this function
2. Click the "Direct Link Setup Enable" checkbox
Figure 7-1
3. Click the Network Tab to switch to the wireless router
signal that support DLS function
4. Fill in the blanks of Direct Link with MAC Address of
Station you want to connect to like Figure 7-2. The
station must meet these two conditions:
1. Connect with an AP that supports DLS features.
2. Ensure that DLS is enabled.
Figure 7-2
5. The Timeout Value indicates the time in seconds before
it disconnects automatically. The value is an integer. The
integer must be between 0~65535. A zero value
specifies that it stays connected. The default Timeout
Value is 60 seconds.
Figure 7-3
- 37 -