Radio Shack 43-3856 - Manual (Page 18)

T
he Integr
ated Answering De
vice
18
Setting a Personal Security Code (PIN)
To play your messages from a remote location, you
need to enter a two-digit Personal Identification
Number (PIN) code (01-99). To select a PIN,
perform the following steps: Ô
1. Press MENU/CLOCK twice in standby mode.
“Security code” and the current PIN code is
announced as it is displayed on the base.
Then the system announces the guidance for
setting the PIN code.
2. Press /VOL/SEL or /VOL/SEL until the
desired number appears.
3. Press SET to select the PIN code. You hear a
confirmation tone. Then the announcement
“Security code” and the new PIN code is
announced. After a few seconds, the system
announces “To set ring time, press menu
again”.
Setting the Ring Time
The ring time setting allows you to set the number
of rings the caller hears before your answering
system plays the outgoing message. You can set
the ring time to answer after two, four, or six rings.
Set to [ ] (Toll Saver) so the answering system
picks up after two rings if you have new messages,
and after four rings if there are none. This way, if
you make a long distance call to check your
messages, you can hang up after the second ring to
avoid billing charges.
1. Press MENU/CLOCK three times in standby
mode.
You hear “Ring time” and the current ring time
([ ] two, [ ] four, [ ] six, [ ] Toll saver), and
it is displayed on the base. Then you hear the
guidance for setting the ring time.
Ô
NOTE
Ô
The PIN code is set to “80”
when you purchase your
phone.
43-3856.FM Page 18 Saturday, February 28, 2004 6:45 PM