RedMax EBZ3050RH - Manual (Page 11)

US-11
EBZ3050RH
U
S
8. Operation
■ STARTING ENGINE
• Avoid operating the blower with the
flexible tube and swivel joint
disconnected. That will reduce the
cooling air and the engine could be
damaged by overheating.
1. Push the primer bulb until fuel flows out
in the clear tube. (F6)
(1) Primer Bulb
2. When the engine is cool, close the
choke. (F7)
(1) Choke Lever
(2) CLOSE
(3) OPEN
3. Set the ignition switch to the start
position. (F8)
4. Set the throttle lever in idling position.
(F8)
(1) Full Throttle
(2) Idling
(3) Ignition Switch
5. To start, hold the top of the blower
firmly and hold the flame by your foot.
Pull the starter knob slowly until you
feel it engage and then give it a
vigorous strong pull. (F9)
• Avoid pulling the starter rope out to
its full extent and allowing the
starter rope to snap back. This will
prevent premature damage to the
starter.
• Do not let a person stand near the
blower or the exhaust port.
• Never to touch the muffler, spark
plug, other metallic parts of the
engine or engine cover while the
engine is in operation or
immediately after shutting down the
engine. These metallic parts and
IMPORTANT
IMPORTANT
F6
F9
(1)
F10
(1)
(2)
(3)
F8
F7
engine cover reach high
temperatures during operation and
doing so could result in serious
burns.
6. Once the engine is running, gradually
open the choke if it was set closed, and
let the engine run at idle speed for a
minute to warm it up.
When the engine fails to start after
several attempts due to overchoking,
open the choke and repeat pulling the
rope.
■ ADJUSTING IDLE SPEED (F10)
• The idling speed is set for 3000 rpm at
the factory. If it is necessary to adjust
the idle speed, use the adjustment
screw on the top side of carburetor.
(1) Idling Adjustment Screw
■ STOPPING ENGINE
• Move the throttle lever to the idling
position and set the ignition switch to
the stop position. (F11)
(1) Ignition Switch
If the engine won’t stop when setting
the ignition switch to the stop position,
close the choke lever and stop the
engine.
In this case, please repair the machine
at your nealest servicing dealer. (F12)
(1) Choke Lever
(2) CLOSE
(3) OPEN
NOTE
NOTE
(1)
F11
F12