Regency Liberty Gas Fireplace L676-NG1 - Manual (Page 28)

Regency ® L676-1 Direct Vent Gas Fireplace 28
INST
ALLA
TION
CONVERSION KIT #522-969 FROM NG TO LP
INSTALLATION
LP Conversion Kit Contains:
Qty. Part # Description
1 910-582 LP Conversion Coil
1 910-037 LP Pilot Orifi ce
1 904-645 Orifi ce #51
1 904-529 Allen Key
1 918-590 LP Conversion Decal
1 908-528 Red Propane Label
1 918-742 Instruction Sheet
5) Remove the grate by undoing the 3
screws.
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER, IF IN DOUBT DO NOT DO THIS CONVERSION!!
c. Place the door on a soft surface to prevent
scratching.
Grate
3) Remove the glass door.
a. Release the 2 door latches on the left
and right side at the top of the fi rebox.
b. Swing the door out from the top and release
the hinge on the left side of the door and
lift out.
Latch
Latch Location
Door Hinge
Front Cover Plate Right Side Pin Shown
2) Remove the front cover plate by lifting up
off of the pins on the left and right side of
the fi rebox.
Right Side Rod with Screen Removed
1) Remove the right side mesh by gathering the
mesh together and lifting the curved end of
the rod up and out of the bracket located on
the top right of the glass frame.
Now slide the straight end of the rod out from
the bracket located on the middle inside top
of the outer shell. Repeat for left side.
Burner Orifi ce Cover Plate
4) Remove the burner orifi ce cover plate from
the log tray by undoing the 2 screws.