Rosen Entertainment Systems EM-1 - Manual (Page 9)

1 2
3
4
3 Installing Your EM1
1.4 screws 10-32 x 1 Fhp 100 degree
2. # 10 washer ss 100 degree
3. Mounting baseplate
4. EM1 Main FPD Assembly
Note :
Mounting plate is
only used when
you want to
surface mount
your EM1
Interface cable
Page 6
3 Installing Your EM1
C. Mounting on Wall to J-Box
• The EM1 is designed to mount in a round 3 1/2”
electrical junction box (J-Box) like the one
shown below.
• Make sure J-Box is secure before mounting
monitor assembly.
• Route 15ft interface cable from j-box to desired
Tuner module location.
• Use a 1/8” standard flat screw driver to remove
the base cover using the access notch as shown
below. When removing, be careful not to scar or
damage cover.
Page 7
Note:
A J-box may be purchased at any local
hardware store
J-Box