Ryobi csb140lz - Manual (Page 12)

12
ASSEMBLY
WARNING: :
Current attachments and accessories available for use
with this tool are listed above. Do not use any attach-
ments or accessories not recommended by the manufac-
turer of this tool. The use of attachments or accessories
not recommended can result in serious personal injury.
EDGE GUIDE
Use the edge guide provided when making long or wide rip
cuts with the saw.
TO ASSEMBLE EDGE GUIDE
See Figure 5.
Follow these directions to assemble the edge guide.
n
Unplug the saw.
n Place edge guide through holes in base as shown in the
figure.
n Adjust edge guide to the width needed.
n Tighten edge guide knob securely.
DUST NOZZLE KIT
See Figure 6.
Dust nozzle kit is provided with the saw. As shown in the
figure, the adapter fits over the dust chute which is located on
the upper blade guard.The nozzle attaches to the adapter.
NOTE:
If you use the nozzle, you should always connect it
to a standard vacuum hose.
TO ATTACH DUST NOZZLE
Follow these directions to attach the dust nozzle.
n
Unplug the saw.
n Lift lower blade guard.
n Orient adapter to fit into the dust chute opening on upper
blade guard.
n Secure adapter with screw provided.
n Align hole in nozzle with raised lip on adapter and snap
into place when using a vacuum hose.
Fig. 5
Fig. 6
EDGE GUIDE
EDGE GUIDE
KNOB
ADAPTER
RAISED
LIP
SCREW
NOZZLE
HOLE
DUST
CHUTE