RCA VR704HF - Manual (Page 24)

22
Setting Up the VCR
PREFERENCES
1 Remote Control: VCR2
2 Auto Play:
ON
3 Auto TV/VCR: ON
4 EnergySaver: 2:00
5 Front Panel: AUTO
6 Tape Speed: SLP
7 Set Auto Repeat
8 Commercial Advance
0 Exit
The VCR will only respond to the VCR2 button. To change
the remote setting back to VCR1, display the PREFERENCES
menu, press 1, and then press the VCR1 button on
the remote.
Auto Play
This feature allows the VCR to automatically start playing
when you insert a tape with the safety tab removed. Press
2 to switch between ON or OFF.
• Select ON if you want a tape with its safety tab
removed to start playing automatically when the tape
is inserted.
• Select OFF if you do not want a tape with its safety tab
removed to start playing automatically.
Auto TV/VCR
This feature controls whether the TV/VCR switch changes
automatically to the VCR mode, when the VCR is turned
on. Press 3 to switch between ON and OFF.
• Select ON if you want the VCR to switch to the VCR
mode when the VCR is turned on. This only applies if
you connect the IN FROM ANT. and OUT TO TV jacks of
your VCR and TV and watch your VCR on channel 3 or
4 of your TV.
• Select OFF if you want the VCR to remain in the TV
mode. This is useful if you watch your VCR on the TV’s
video input and you don’t want your antenna/cable
signal interrupted by the VCR.
Auto TV/VCR
Pressing TV•VCR on the VCR
(ANTENNA on remote) will still switch
between the VCR and TV modes.
VCR mode: VCR indicator in the
display panel lights.
TV mode: VCR indicator turns off.