Regent Sheffield CMS240W - Manual (Page 4)

4
Step 2: Turn on the power to fixture. Allow fixture to warm up
approximately 90 seconds before testing. (Lights may
or may not come on during warm-up period.This is
normal.)
Step 3: Aim sensor head in desired position. NOTE: Maintain
air spacing between lamps and sensor head, at least
1”. Make sure sensor head is positioned with
control switches facing towards the ground.
Step 4: Walk across the detection zone at the farthest distance
you wish your detector to detect motion.
Step 5: Adjust sensitivity until you get desired results. For
more range, aim sensor head slightly upwards . For
less range, aim sensor head slightly downward. Lights
will turn off 4 seconds after all motion stops.
Step 6: Move slide switch to 4 MIN or 12 MIN (AUTO mode),
or to one of the three NIGHT TIME ON settings. At dusk,
lights will operate in the AUTO or NIGHT TIME ON settings.
How to select your desired featur e
(continued)
Test Setting
Lights should turn on with
motion both day and
night. Lights should turn
OFF after 4 seconds.
TEST Keep the power to
the fixture on.
Motion Activated
(auto setting)
Lights should turn on with
motion only at night and
should turn off after 4 or
12 minutes of no motion.
AUTO 4 MIN
or
AUTO 12 MIN
Keep the power to
the fixture on.
Mode of
operation:
Set slide switch
on sensor to:
How to set
power switch:
2 Hour
NIGHT TIME ON then
Motion Activated
Lights should turn on
automatically at night
100% brightness for 2
hours, then reset to
regular auto motion
setting for the remainder
of the evening.
NIGHT TIME ON
2 HR
(2 Hours)
Note: Once the light has come onin
the selected NIGHT TIMEONmode,
you cannot change the mode setting
until the next dawn. The light will
operate in the first NIGHT TIMEON
mode selected (2 hour, 4 hour, or
6 hour), even if changed.
Keep the power to the
fixture on.
4 Hour
NIGHT TIME ON then
Motion Activated
Lights should turn on
automatically at night
100% brightness for 4
hours, then reset to
regular auto motion
setting for the remainder
of the evening.
NIGHT TIME ON
4 HR
(4 Hours)
Note: Once the light has come onin
the selected NIGHT TIMEONmode,
you cannot change the mode setting
until the next dawn. The light will
operate in the first NIGHT TIMEON
mode selected (2 hour, 4 hour or
6 hour), even if changed.
Keep the power to the
fixture on.
TEST
4 MIN
M 12 MIN
2 HR
4 HR
H
L
MODE
SENSITIVITY
6 HR
F