Roland PICZA LPX-60 - Manual (Page 59)

57 5. What to Do If...
5-2 When Moving the Machine
4 Position the head retainer, then provisionally tighten the Y screws in the sequence shown in the figure below.
5 Lift the head knob until it strikes the retainer, then use Y screws to fasten the head to the retainer.
Finally, firmly tighten all screws to secure in place.
6 Secure the table in place using X screws.
Adjust the position of the table so that the screw locations are lined up.
Adjust the table so that an imaginary line connecting the two screw holes is perpendicular to the front surface of the
machine.
After tightening the screws, check to ensure that the table is fastened securely.
Reference
point
Y screws Y screws
Y screws
X screws
Knob
Using the protrusion at the front of the ma-
chine as the reference point, provisionally
tighten at the front. Move the head back slightly toward the front,
line up the inner end of the retainer with the
screw locations, then tighten provisionally.