Radio Shack PRO-2096 - Manual (Page 20)

20
The Basics
basic scanning
Press SCAN to begin scanning channels. The scanner scans
through all channels in the active channel storage bank. See
“About Channel Storage Banks”.
• You must store frequencies into channels before you can
scan them. The scanner does not scan through empty
channels.
• To change the scanning direction, press e or d while
scanning.
about channel-storage banks
• To turn on a channel storage bank, press the number
key corresponding to the desired bank until the bank’s
number appears on the display.
• To turn off a channel storage bank, press the number
key corresponding to the desired bank until the bank’s
number disappears from the display.
• The scanner does not scan channels within a bank you
have turned off; however, you can manually select any
channel in a storage bank, even if the bank is turned off.
• You cannot turn off all channel storage banks. There must
always be at least one active channel storage bank.
monitoring a single channel
You can monitor a single channel by manually navigating to
that channel. The scanner will receive transmissions only on
that frequency.