Linking the mouse and receiver, 6linking the mouse and receiver – RocketFish RF-LTRMS User Manual
Page 6
6
Linking the mouse and receiver
The mouse has 256 identification codes that allow the
mouse and its receiver to operate without interference from
other RF devices. After your computer detects the USB
receiver and the default driver is installed, you must make a
communications link between the mouse and its receiver
before you can use the mouse.
To make a communications link:
1 Press and release the link button on the receiver. The
receiver’s status light blinks green when the receiver is
activated.
2 Press and release the link button on the bottom of the
mouse. The two devices establish their communication
link. The receiver’s status light first blinks green, then
turns red when the connection is made.
The mouse is now ready to use.
Receiver link button
Receiver link button
RF-LTRMS_08-1740 ENG.fm Page 6 Thursday, October 16, 2008 3:27 PM