ResMed VPAP III & III ST - Manual (Page 38)

32
There is excessive leak. Adjust position of mask and
headgear.
Plugs may be missing from
ports on mask. Replace
them.
Air tubing not connected
properly. Connect firmly at
both ends.
Air tubing kinked or
punctured. Straighten or
replace.
VPAP unit does not
stop when you remove
your mask. SmartStart/Stop is disabled.
Use of an Ultra Mirage Full
Face Mask.
Enable SmartStart/Stop.
SmartStop does not work
with a full face mask.
SmartStart is enabled
but the flow generator
does not stop
automatically when
you remove your mask. Incompatible humidifier or
mask system being used. Use only equipment as
recommended and supplied
by ResMed.
Display error message:
Check tube!!
Key if done
The air tubing is loose. Check that the air tubing is
connected securely to your
mask and the air outlet on
the front of the VPAP.
To clear the error message,
press any key on the VPAP
keypad.
Displays error
message:
SYSTEM ERROR
Call service!
Component failure. Return your VPAP for
servicing.
Problem Possible Cause Solution