Radio Shack VG-2 Guard - Manual (Page 13)

13
Note: The tape’s adhesive might not stick to a sur-
face treated with vinyl cleaner or protectant.
2. Peel off the paper backing on one side of both
pieces of tape, then apply both pieces of tape to the
bottom of your detector.
Notes:
• If you are mounting the detector on a curved dash-
board, you might need to cut the hook-and-loop
tape in half and use one strip in each corner of the
bottom of the detector.
• Do not place the hook-and-loop tape over the
detector’s serial number.
3. Remove the paper backing from the other side of
the tape and press your detector onto the dash-
board.
VISOR MOUNTING
The supplied sun visor clip and bracket holder let you
quickly mount the detector on your vehicle’s sun visor.
22-1676.fm Page 13 Friday, August 6, 1999 10:38 AM