Ryobi TS1550 - Manual (Page 20)

20
ADJUSTMENTS
SQUARING THE MITER TABLE TO THE
FENCE
See Figures 18 through 22.
Follow these directions to square the miter table to the
fence.
■ Unplug the saw.
WARNING:
Failure to unplug the tool could result in accidental
starting causing possible serious personal injury.
■ Push down on the saw arm.
■ Pull out the lock pin to release the saw arm.
■ Raise the saw arm to its full raised position.
■ Loosen the miter lock handle by rotating it approxi-
mately one-half turn.
■ Loosen the socket head screws securing the miter
lock lever.
■ Grasp the miter lock handle and rotate the miter
table until the miter pointer is positioned at 0°.
■ Tighten the miter lock handle securely.
■ Tighten the socket head screws to secure the miter
lock lever.
■ Lay a framing square flat on the miter table.
■ Place one leg of the square against the fence.
■ Place the other leg of the square beside the zero
clearance throat plate in the miter table.
NOTE: The edge of the square and the zero
clearance throat plate in the miter table should be
parallel. If the edge of the framing square and the
zero clearance throat plate in the miter table are not
parallel, adjustments are needed. Continue as follows.
■ Loosen the socket head screws securing the fence.
■ Adjust the fence until the framing square and zero
clearance throat plate are parallel.
■ Retighten the screws securely and recheck the fence-
to-table alignment.
Fig. 20
Fig. 18
PULL OUT
LOCK PIN
PUSH DOWN
ON ARM
Fig. 19
SOCKET
HEAD
SCREW
MITER LOCK
HANDLE
30 30
15 15
0 0
15 15
30 30
MITER
POINTER