Loading the battery – Ricoh RDC-7 User Manual

Page 26

Advertising
background image

24

Loading the Battery

Load the battery (rechargeable lithium ion battery) before operating the camera.

Important

Note

• Before using the camera for the first time, be sure to charge the

battery. (The battery leaves the factory in an uncharged state.) See
[Charging the Battery]

→

p.23.

q

Check that the camera is turned off,
and then open the battery cover by
pressing and sliding it in the direction
shown.

See

• “Turning on the Camera” (p.41).

w

Load the battery.

Important

Note

• Do not bring metallic objects, such

as a needle, into contact with the
battery contact surface or electrical
connections. Electrostatic damage
could result.

e

Close the battery cover.

Close the battery cover until it clicks into position.

●

Shooting and Playback Guidelines

The table below shows the approximate recording and playback times, as
measured under the following test conditions:
[Test conditions]
During shooting: Shoot continuously in recording mode with the power turned

on (shoot at intervals of 30 seconds, without turning the
camera off in the middle, with the flash fired 50%, at a
temperature of 20°C)

During playback: Leave the camera continuously turned on in playback mode at

a temperature of 20°C

Battery Type

Lithium ion battery

(fully charged)

Approximate Recording Time

Approximate Playback Time

50 minutes

50 minutes

Advertising