D beam (assignable), 50 playing in patch mode – Roland X-6 User Manual
Page 50
50
Playing in Patch Mode
LFO Osc 1 Pitch Depth
Specifies the depth to which the LFO will modulate the OSC1 pitch.
Value:
-63–+63
LFO Osc 2 Pitch Depth
Specifies the depth to which the LFO will modulate the OSC2 pitch.
Value:
-63–+63
LFO Osc 1 Pulse Width Depth
Specifies the depth to which the LFO will modulate the pulse width
of the OSC1 waveform.
*
The Pulse Width is activated when “SQR” is selected with OSC1/2
waveform.
Value:
-63–+63
LFO Osc 2 Pulse Width Depth
Specifies the depth to which the LFO will modulate the pulse width
of the OSC2 waveform.
*
The Pulse Width is activated when “SQR” is selected with OSC1/2
waveform.
Value:
-63–+63
Range (Solo synth range)
Specifies the range in which the pitch of the solo synth will vary.
Value:
2 OCTAVES, 4 OCTAVES, 8 OCTAVES
D Beam (Assignable)
By assigning a variety of functions to the D Beam controller you can
apply different effects to the sound in real time.
fig.05-020_50
For details on these settings, refer to
Type
Specifies the function controlled by the D Beam controller.
Value
CC01–31, 33–95:
Controller numbers 1–31, 33–95
For more information about Control Change messages, please
refer to
Bend Up:
Raises the pitch in semitone steps (up to 4
octaves higher).
Bend Down:
Lowers the pitch in semitone steps (up to 4
octaves lower).
Start/stop:
Starts/Stops the sequencer.
TAP Tempo:
Tap tempo (a tempo specified by the interval
at which you move your hand over the D
Beam controller).
Arp Grid:
Arpeggio Grid
Arp Duration:
Adjusts the duration of each arpeggiated
note
Arp Motif:
Arpeggio Motif
Arp Oct Up:
The range in which the arpeggio is sounded
will rise in steps of an octave (maximum 3
octaves).
Arp Oct Down:
The range in which the arpeggio is sounded
will lower in steps of an octave (maximum 3
octaves).
Range Min (D Beam Range Lower)
Specify the lower limit of the range of the D Beam controller.
Value:
0–127
Range Max (D Beam Range Upper)
Specify the upper limit of the range of the D Beam controller.By
setting Range Max below Range Min you can invert the range of
change.
Value:
0–127
Fantom-X678_r_e.book 50 ページ ２００７年３月２０日 火曜日 午前１０時２０分