Russound CAV6.6-S2 - Manual (Page 52)

52
INSTALLER
INSTALLATION MENU
Numeric IR (cont’d)
ii. MACRO ID – Enter the macro ID number. Menu advances to SUFFIX CMD (step 9)
e. All Other Selections: Procedure advances to DEVICE CODE (step 7)
7. DEVICE CODE (f) – Source component code for IR control.
8. KEY FUNCTION (f) – Select a function (Disc, etc.).
9. SUFFIX CMD (f) – Tells the system whether a command will be issued after the
selection of the numerical value (e.g., 1, 2 Enter). If “no,” proce-
dure advances to SAVE CHANGES (step 13)
10. COMMAND TYPE (f) – Select the type of source command (e.g., CD, TV, etc.).
a. Selected: Learned IR Choose Learned IR if the pre-programmed IR code library does
not support the source component.
i. LEARNED SRC (f) – Select the learned source bank to be assigned to the source
component. Procedure advances to KEY FUNCTION (step 12)
b. Selected: Unassigned The numeric IR Suffix command is cleared. Procedure advances
to SOURCE NUM (step 1)
c. Selected: Default Default selects the same device type and device code previously
setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 12)
d. Selected: Macro: (To build macros, see Macro Editor page 57)
i. MACRO - Macro loads a series of commands which are processed when
activated.
ii. MACRO ID – Enter the macro ID number. Menu advances to SAVE CHANGES
(step 13)
e. All Other Selections: Procedure advances to DEVICE CODE (step 11)
11. DEVICE CODE (f) – Source component code for IR control.
12. KEY FUNCTION (f) – Select a function (Enter, Play, etc.).
13. SAVE CHANGES? (f) – Select “yes” to save the changes.
SRC SEL CMD (p)
This procedure permits a command to be sent to the source component when the source component
is initially selected. See Source Setup Menu on Page 48 and Source Select Command & # Of
Sources - Flow Chart on page 63
1. SOURCE NUM (f) – Select the source number this command will be configured for.