Adjustments – Ryobi BTS15 User Manual

Page 31

Advertising
background image

Page 31

ADJUSTMENTS

WARNING:

Before performing any adjustment, make sure the tool is
unplugged from the power supply and the switch is in the
off ( ) position. Failure to head this warning could result
in serious personal injury.

TO SET BLADE AT 0

°

OR 45

°

See Figure 40.

The angle settings of your saw have been set at the factory
and, unless damaged in shipping, should not require setting
during assembly. After extensive use, it may need to be
checked.

Raise the blade and the blade guard.

If the blade is not perfectly vertical (0

°), loosen the

adjustment bolt and the bevel locking lever.

Place a framing square beside the blade on the left. Lock
the angle by pushing the bevel locking lever and retighten
the adjustment bolt.

Adjust the bevel indicator to zero.

If the blade is not an exact 45

°, loosen the adjustment bolt

and the bevel locking lever.

Turn the bevel handle until the bottom of the blade has
moved completely to the left side of the slot. Lock the
angle by pushing the bevel locking lever.

If the blade is not an exact 45

°, loosen the adjustment bolt

and the bevel locking lever.

Adjust the bevel indicator to 45

°.

Make a test cut.

Fig. 40

BEVEL

LOCKING

LEVER

BEVEL

HANDLE

BEVEL

INDICATOR

0º ADJUSTMENT

BOLT

FRAMING SQUARE

45º

BEVEL

LOCKING

LEVER

45º ADJUSTMENT

BOLT

BEVEL

HANDLE

BLADE

BLADE

Advertising