Remington OCN6 - Manual (Page 10)

Manual GPS configuration
If you know where and how the GPS is connected, select
Config. instead of Detect.
In the next screen you need to set the communication protocol (NMEA or SIRF), the
communication port (e.g. COM1 or COM4) and the communication speed in Bauds
(4800, 9600, 19200, 38400 or 57600).
Having connected the GPS receiver with your settings, tap OK to return to the GPS Data
screen, or tap the arrow in the top left corner to cancel the operation leaving the factory
settings untouched.
If you have selected OK and your settings are correct, the result will be the same as with
the Detect function. The green light on the left will start blinking immediately, and after a
short wait
satellite positions, signal strength bars, actual coordinates, date, time, accuracy,
elevation and speed will be displayed. Now you can return to the main screen by tapping the
arrow in the top left corner. The satellite dish in the bottom left corner is