RCA VR355/VR545 - Manual (Page 10)

8 Chapter 1
Connections & Setup
TV + VCR
Note: Your television back panel may not look exactly like the model
shown here.
1. Connect the VCR to the TV
Connect one end of the supplied RF coaxial cable to the RF OUT jack on
the back of the VCR and the other end to the TV’s Antenna IN jack.
2. Connect the antenna/cable feed to the VCR
Connect the cable or antenna RF coaxial cable to the ANT. IN jack on your
VCR.
Note: Flip the CH 3/4 switch on the back of the VCR to the channel that is
not used in your area. This will be the channel that the TV must be tuned
to in order to see the VCR’s picture.
Go To Page 11
VCR
TV
CH
ANT. IN
OUT IN
AUDIO
VIDEO
3 4
RF OUT
VCR
TV (back panel)
CABLE/
ANTENNA
VIDEO
R L / MONO
S-VIDEO
AUDIO
L
IN
OUT
From Cable
or Antenna
1
2