Tools needed, Assembly, Warning – Ryobi 4060310 User Manual

Page 4

Text mode
Original mode

Advertising

TOOLS NEEDED

Fig. 3

INSTALLING THE MITER SLOT TABLE

See Figure 3.

■

Turn the ON/OFF switch to the OFF position.

■

Unplug the saw from the switched on-board outlet.

■

Disconnect the saw from the power supply.

■

Remove the sliding miter table and accessory table
from the saw.

■

Place the miter slot table onto the saw as shown in
Figure 3.

WARNING:

The table saw should never be connected to a power
supply while you are assembling parts. Disconnect-
ing the table saw will prevent accidental starting that
could cause serious personal injury.

ASSEMBLY

7/16 in. NUT DRIVER

Fig. 2

3/16 in. HEX KEY

1/4-20 x 1 in.

HEX CAP SCREW

WASHER

1/4-20 NUT

SHIMS

MITER

SLOT TABLE

Advertising