Radio Shack ET-469 - Manual (Page 11)

11
DISABLING LINE 2
Should you ever need to disable Line 2,
leave the handset in the cradle and
press
HOLD , LINE 2 , then .
To enable the Line 2 indicator, leave the
handset in the cradle and press
HOLD ,
LINE 2 , then #.
SETTING THE DIALING
MODE
Set T/P (Tone/Pulse) on the back of the
phone for the type of service you have. If
you are not sure which type you have,
do this test.
1. Press LINE 1 .
2. Set T/P to T .
3. Press any number other than 0 .
If the dial tone stops, you have
touch tone service. Leave
T/P set to
T .
If the tone continues, you have
pulse service. Set
T/P to P .
SETTING THE RINGER
The lines on your phone ring with differ-
ent tones when you receive a call. You
can set the phone lines to ring at the
same volume, at different volumes, or
not at all.
To set each ringer’s volume, set RINGER
OFF/LO/HI for that line to the desired po-
sition.
If you do not want a line’s ringer to
sound, set
RINGER OFF/LO/HI for that
line to OFF . The line indicator will light
when a call comes in. You can still re-
ceive and make calls on that line.
CONFIRMING THE LINE
NUMBERS
Follow these steps to determine which
phone number is connected to which
line.
1. Press LINE 1 then lift the handset.
2. Dial one of your phone numbers. If
the Line 2 indicator flashes, the
number is connected to Line 2. If
you hear a busy signal, the number
is connected to Line 1.
After you confirm the phone number for
each line, write each number on the
name and number directory located
above the
L1 and L2 buttons.
43-469.fm Page 11 Tuesday, January 19, 1999 9:48 AM