Raymarine DSM30 - Manual (Page 20)

20 DSM300 and DSM30 Installation Manual
Configuring hsb 2 PLUS (Pathfinder) Series Displays
hsb 2 PLUS network cables have a triangular 3-pin connector on both ends. When
using the DSM with an hsb 2 PLUS Series display, connect the supplied 4-pin to
3-pin hsb 2 adapter between the sounder module and the network cable.
The hsb 2 system must be terminated at both ends of the network. If a PLUS Series
display is the last device on the network, an inline terminator is installed on the
cable where it connects to the display. The network connection in the DSM,
however, is internally terminated; it does not require an inline terminator.
Because the sounder module is internally terminated, it must be
installed at the end of the hsb
2 network. You must not use an inline
terminator on the DSM end of the network. If an hsb 2 splitter is
used, connect it to a display and not to the DSM.
Configuring an hsb 2 PLUS System - Single Display
Configuring an hsb 2 PLUS System - Multiple Displays
3-pin to 3-pin hsb 2 cable
R69081
Sounder Module
R58117
hsb 2 Inline
Terminator
4-pin to 3-pin
hsb 2 adapter
D9606-1
hsb 2 PLUS Series Display
Sounder Module
R55040
3-pin hsb 2 cable 3-pin hsb 2 cable
hsb 2
Splitter
R58117
hsb 2 Inline
Terminator
R69081
4-pin to 3-pin
hsb
2 adapter
D9607-1
hsb 2 PLUS Series Display hsb 2 PLUS Series Display