Radio Shack 43-3701 - Manual (Page 14)

Basics
14
Base Ringer Volume
The ringer control for the base of your
cordless phone allows you turn the ringer
OFF or to select LO/HI volume for each line
1 or line 2.
Base Speaker Volume
To control the speaker volume of the base,
press
VOLUME/ or VOLUME/ during a call.
There are 7 speaker volume levels.
R EDIAL
The REDIAL/PAUSE key redials the last
number dialed. The redialed number can be
up to 32 digits long. Ô
Handset
Press line 1 or line 2 , then press REDIAL/
PAUSE .
Or press REDIAL/PAUSE , then press line 1 or
line 2 .
Base
Press line 1 or line 2 , then press REDIAL/P .
If any key is pressed before REDIAL/P , the
last number will not redial.
T ONE D IALING S WITCH - OVER
Some telephone companies use equipment
that requires pulse dialing (sometimes
referred to as rotary dialing). If you need to
enter tone dialing digits, you can switch-
over to tone dialing during the call. For
example, entering your bank account
number after you have called your bank.Ô
Initially make your call with the pulse dialing
mode. Once your call connects, press
/
tone/< . Enter the desired number. These
Ô
NOTES
Ô
Redial
The cordless phone has
two independent last
number redial memories;
one in the handset, the
other in the base.
Tone Dialing Switch-over
•
The tone feature only
applies when the dial
mode is set to pulse.
• This special number can
be stored in a memory
location. This is referred
to as Chain Dialing.
43-3701.fm Page 14 Thursday, April 24, 2003 11:56 AM