Rayming TN-200 - Manual (Page 14)

PAGE 14 OF 33
UG-TN200 V1.3
TN-200
Once the installation of the serial port has completed confirm that the installation has been successful
by looking under Device Manager of the System Properties screen. The device should have installed
as a USB Serial Port (COMx) attached to USB High Speed Serial Converter.
The screen below is shown after selecting Control Panel -> System Properties -> Hardware -> Device
Manager, then Select View -> Devices by connection.
Screen 7
To change the virtual COM port properties select the USB Serial Port and then click Properties. This
allows you to change serial port properties such as COM port number, baud rate, data bits etc. Of
particular use is the ability to change the COM port that is assigned to your device.