RadioLAN Campus BridgeLINK - Manual (Page 29)

890-007 Rev. A 01/28/99 Page 19 © 1999 RadioLAN, Inc.
Use a pencil to mark the brackets screw hole locations onto the
surface upon which you will mount the CPU.
At the location’s screw holes, install any necessary anchoring
devices. This is especially recommended when installing the CPU
onto a sheet-rock or gypsum surface.
Hold the CPU up to the mounting surface (see Figure 15),
orienting the screw holes with the mounting anchors, then drive
screws securely into the surface. Tighten down the screws.
Connecting the Network
When connecting the CPU to the hardware network hub or to a
PC, you must use a RJ45-compatible, dual modular cable. The
cable is an eight-wire, twisted-pair cable and must not exceed the
distance limitations provided by the IEEE 802.3 standard. After
routing the cable to the network, insert the modular connector into
the port on the CPU.
Figure 15: Marking Screw Locations