Set up – RedMax BCZ2600S User Manual

Page 15

Advertising
background image

15

6. Set up

SE10

SE11

■ INSTALLING CUTTING HEAD (SE10)
1. While locking the gear shaft, by inserting the

supplied tool into the upper holder on the gear
box, loosen and remove the hexagon nut(left-
handed)

2. Fit the holder attached to the upper holder. Then

screw in the cutting head to the gear shaft over
the holders. Hand-tighten it securely.

■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit balances with

head just touching on the ground. (SE11)

Advertising
See also other documents in the category RedMax Tools: