Operation, Warning – Ryobi HP1201M User Manual

Page 7

Advertising
background image

Page 7

OPERATION

Fig. 1

KNOW YOUR DRILL-DRIVER

See Figure 1.

Before attempting to use any tool, familiarize yourself with all
operating features and safety requirements.

WARNING:

Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict severe injury.

CHARGING YOUR DRILL-DRIVER

The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it at least 6 hours prior to use.

Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by re-
charging) for them to fully charge.

TO CHARGE

■

Charge battery pack only with the charging assembly
provided.

■

Make sure power supply is normal house voltage,
120 volts, 60 Hz, AC only.

■

Connect charging assembly to power supply.

■

Place battery pack in charging assembly. Align raised
rib on battery pack with groove in charging assembly.
See Figure 2.

■

Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charging
assembly. When properly connected, red light will turn
on.

■

After normal usage, 3 hours of charging time is re-
quired to be fully charged. A minimum charge time of 6
hours is required to recharge a completely discharged
battery.

■

The battery pack will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.

■

DO NOT place charging assembly in an area of ex-
treme heat or cold. It will work best at normal room
temperature.

Fig. 2

KEYLESS

CHUCK

BIT

STORAGE

AREA

TORQUE

ADJUSTMENT

RING

SWITCH

TRIGGER

2

4

6

8

CHARGING
ASSEMBLY

BATTERY

PACK

DIRECTION

OF ROTATION

SELECTOR

LEVEL

BATTERY

PACK

CHARGE

INDICATOR

LIGHT (LED)

MAG TRAY™

(SCREW HOLDER)

Advertising