Ryobi CSB141LZ - Manual (Page 12)

12
ASSEMBLY
Fig. 4
WRENCH
SPINDLE
LOCK BUTTON
REMOVING BLADE
See Figure 4.

Unplug the saw.
 Depress spindle lock button.
 Remove blade screw by turning it counterclockwise with
the wrench.
 Remove spring washer and outer blade washer
(“D” washer).
 Lift lower blade guard.
 Remove blade.
EDGE GUIDE
See Figure 5.
Use the edge guide when making long or wide rip cuts with
the saw.

Unplug the saw.
 Place edge guide through holes in base.
 Adjust edge guide to the width needed.
 Tighten edge guide knob securely.
DUST NOZZLE KIT
See Figure 6.
The dust nozzle kit directs saw dust away from the operator.
The adaptor fits over the dust chute which is located on the
upper blade guard. The nozzle attaches to the adaptor.
NOTE:
If you use the nozzle, you should always connect it
to a standard vacuum hose.

Unplug the saw.
 Lift lower blade guard.
 Orient adaptor to fit into the dust chute opening on upper
blade guard.
 Secure adaptor with screw provided.
 Align hole in nozzle with raised lip on adaptor and snap
into place when using a vacuum hose.
Fig. 6
ADAPTOR
RAISED LIP
SCREW
NOZZLE DUST CHUTE
OPENING
HOLE
EDGE GUIDE
EDGE GUIDE
KNOB
Fig. 5
BLADE
SCREW