Radio Shack 9" COLOR TV/VCR COMBO 36 - Manual (Page 35)

35
Dubbing a Tape
Note: For the best results while dubbing, hold
the remote control close to the Model 36’s infra-
red window when you press a button. Other-
wise, the remote control might affect the
dubbing source’s operation.
1. Prepare the dubbing source to play a tape.
2. Insert a blank cassette, or one that you
want to record over, into the Model 36’s
cassette compartment. The Model 36 turns
on.
3. Enter 00 using the remote control’s number
buttons, or press CHANNEL s or CHANNEL t
to select one channel higher than the high-
est programmed channel or one channel
lower than the lowest programmed chan-
nel.
AUX appears on the Model 36’s TV
screen.
4. Repeatedly press SPEED on the remote
control until the desired recording speed
(
SP , LP , or SLP ) appears on the TV screen.
5. Press REC/OTR on the Model 36 or
RECORD on the remote control to begin
recording.
6. Start the dubbing source.
7. To turn the TV picture off or on while
recording, press POWER .
8. Press STOP on the remote control or STOP/
EJECT on the front of the Model 36 to stop
recording before it automatically stops at
the end of the tape. Then stop the dubbing
source.
16-429.fm Page 35 Tuesday, July 20, 1999 3:50 PM