Test the laserdisc player, Test the audio cd player, Test the system – RCA HT35752BD User Manual
Page 26
24
Test the System
(continued)
➤ Test the Audio CD Player
See the audio CD player’s use and care guide for complete CD player operating
information.
❑
1.
Press AUDIO SHIFT, then CD on the remote or POWER on the player to turn on
the CD player and audio/video receiver.
❑
2.
Press OPEN/CLOSE on the front of the player to open the disc table.
❑
3.
Load a CD. Press OPEN/CLOSE on the player to close the disc table, and PLAY
to start playing the CD.
❑
4.
Check CD player’s audio signal.
➤ Test the LaserDisc Player
See the LaserDisc player user’s guide for complete LaserDisc player
operating information.
❑
1.
Remove the set screws from the LaserDisc player.
❑
2.
Press VCR2/LD on the remote to turn on the LaserDisc player,
audio/video receiver, TV, and tune the TV to channel 92. This will also
set the remote to operate the player.
❑
3.
Press OPEN/CLOSE on the player to open the disc table. Center a laser
disc in the groove of the table corresponding to the size of the disc
as
shown below.
19
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
PLAY
19
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
PLAY
5-Inch CD (CDV)
3-Inch CD
8-Inch LD
12-Inch LD
CD (CDV) – Place label
side up.
LD* – Place side up you
want to play.
* On two-sided disc, the side facing up will
play first and then the other side will play.
❑
4.
Press PLAY on the remote or PLAY•PAUSE on the player to close
the disc table and start playing the laser disc.
❑
5.
Check the video and audio signals from the player.